Corrosion Resistance Tester

Feature

Product Features

1. Durable hard 8 mm PVC construction, anti-corrosion and easy to clean.
2. Reservoirs with mixing system on stand.
3. Separate heating system apart from salt testing chamber to ensure accurate result and protect circuit.
4. Exposure zone lined with corrosion-resistant PVC sheets.
5. Clear cover allows viewing of test conditions.
6. Peaked cover prevents dripping of condensation onto samples.
7. Water seal and water level protection system.
8. Heated humidifying tower with air relief valve, adjustable tower tip to orient salt fog.
9. Automatic DI water fills to humidifying tower.
10. Digital temperature control.
11. Integral over-protection on heaters.
12. Low water cut-off protection on humidifying tower.

Method of operation

1, the salt spray chamber internal parts: tower spray device, funnel, rod, V-type sample holder installed.2, connected to the gas supply, the power is turned on, turn on the power switch.3, in the pressure tank and cabinets add water, two low level light exterminate stop adding water, at the water seal groove seal.4, purified water and sodium chloride salt in a ratio of 1:20 with a good. The solution was poured into the reagent with a good entrance (low saline to exterminate a lamp).5, we can open all the lamps burn out operation, spray, time switch, switch demisting before opening end of the test.6, according to the test requirements for equipment and cycles for continuous spraying mode (continuous spray T1, T2 tables are all set to 0, T1 is set to intermittent spray working time, T2 is time to rest).

Spesification

The table parameters is for the company Standard Model parameters, we support customer customization parameters

ASTM B117-08, ISO 9227... 

And IEC, MIL, DIN, ASTM and other standards equivalent to